3D printed NEM pocket coupler to fit the original Hornby HST power cars
£6.50A pair of 3D resin printed NEM coupling pockets to fit the original 1980’s Hornby HST to allow the fitting of modern couplings, tension hook, magnetic of Kadee.
Showing all 7 results
A pair of 3D resin printed NEM coupling pockets to fit the original 1980’s Hornby HST to allow the fitting of modern couplings, tension hook, magnetic of Kadee.
3D printed replacement for the Triang class 31 (A1A-A1A) and class 37 traction magnets. With nickel silver rails, the traction magnets no longer aid traction, and cause the wheel sets to pull over to one side. Replacing the magnets with our 3D resin printed alternatives will allow the locomotive to run with centred wheels, while maintaining the other function of the magnet, holding the armature bearings in place and allowing improved low speed running of these old locomotives. Price is for a pair.
3D printed replacement for the Triang class 35 Hymek traction magnets. With nickel silver rails, the traction magnets no longer aid traction, and cause the wheel sets to pull over to one side. Replacing the magnets with our 3D resin printed alternatives will allow the locomotive to run with centred wheels, while maintaining the other function of the magnet, holding the armature bearings in place and allowing improved low speed running of these old locomotives. Price is for a pair.
This listing is for one x 3D resin printed replacement part for Horby part number X627 – Collector assembly. This was used on at least the following 2 0-4-0 locos
R868
R450
This listing is for a single 3D resin printed replacement intermediate gear to fit a Hornby T9. Part of item 16 (X9960) on the locomotive service sheet, the original is made of brass. You will need to re-use the original 2mm diameter shaft and smaller side gear from your locomotive.
If you need the small gear as well, we can supply this too.
This listing is for a single 3D resin printed replacement intermediate gear to fit a Hornby T9. Part of item 16 (X9960) on the locomotive service sheet. You will need to re-use the original 2mm diameter. This is 2 separate gears that become one combined gear when fitted onto your existing 2mm shaft.
This listing is for a single 3D resin printed replacement intermediate gear to fit a Hornby T9. Part of item 16 (X9960) on the locomotive service sheet. You will need to re-use the original 2mm diameter shaft and larger gear from your locomotive.
If you need the larger gear as well, we can supply this too.